If you haven’t seen the first video in this series go check it out:
This video shows the process of wiring and installing all the electronics on my CNC router. Additionally, I do some initial cuts and accuracy tests. I have been pleasantly surprised with the level of accuracy I have been getting from this machine and I am excited about the possibilities it brings for future projects. Put any ideas or suggestions you have in the comment section below!
Links to the hardware used in this project (affiliate links):
Linear Rails and Ballscrews: https://amzn.to/3CEvJOK
Stepper Motors and Controller Board: https://amzn.to/3CFWUsF
Power Supply: https://amzn.to/2VP2p7h
Limit Switches: https://amzn.to/3g2qvmm
E-Stop Button: https://amzn.to/3iJBkLT
source
Comments are closed.