UPDATED DIY VERSION (I made better one): https://www.youtube.com/watch?v=D-22mZZNXHo
I am in the process of building a homemade CNC Plasma table. This table is designed to use a 4ft by 4ft work piece and utilizes LinuxCNC software with HobbyCNC electronics. Plasma cutter is an Everlast Powerplasma 60s with machine torch. This video goes over the frame and computer mounts and motion rails that I am using for the build. The next video will cover electronics! Very fun build! Link to the sliders I used for my build from ebay: https://www.ebay.com/itm/CNC-Router-Plasma-Gantry-Carriage-Rail-Car-NEMA-23-motor-2×2-2×3-or-2×4/123469747929?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
Chapters:
0:00 Introduction
0:41 Parts Overview
2:51 Frame Start
5:19 Slat Holders Installation
6:15 Painting and Hardware
7:15 Final Touches
10:55 Final Overview
source
Comments are closed.