http://www.edgetechnologyproducts.com
The Pro Stop by Edge Technology is designed with the CNC machinist in mind. Its super low profile design stays completely below the top surface of the vise which means it will not interfere with cutting tool paths. It will also keep the stop rod square to the workpiece throughout the entire range of motion. This configuration provides a more consistent locating surface for increased part accuracy. After locating the workpiece the arm of the Pro Vise Stop can be rotated out of the way for total cutter clearance. The arm can then be accurately repositioned for repeat setup. A stop rod collar is also included to allow longer than usual stock lengths to be located.
source